Concrete & Asphalt Demolition, Sawcutting & Coring

Why cutting beats breaking for clean results

A saw cut gives a straight, clean edge so the concrete that stays is not cracked by the demolition around it. Contractors cut along the layout lines first, then break out the slab in sections with breakers or a skid steer. This is especially important next to patios, foundations and walkways you want to keep. Wet cutting controls dust, and slurry is collected so it does not run into drains or onto neighboring property. Share any plans or photos of the area, and tell the contractor about irrigation lines, gas, electrical conduits and drainage you know run beneath the slab.

Core drilling for pipes, vents and anchors

Core drilling uses a diamond bit to make round holes of a precise size through floors, walls and slabs. It is the standard way to run pipes, conduit, vents and drains through concrete without cracking it. Contractors scan for rebar and post-tension cables before drilling, because cutting a tendon is dangerous and expensive. If your slab is post-tensioned, tell the contractor in advance and ask for a scan. Ask how the dust and slurry will be controlled, and whether the contractor will protect nearby landscaping, windows and parked cars from flying debris.

Utilities, debris and getting the site ready

Before demolition, buried utilities should be located, and many areas require a call to the state utility locating service. Asphalt and concrete are heavy, so contractors plan trucks, dumpsters and a place to stage equipment. Recycled concrete is often accepted by local facilities. After the removal, the base is graded and ready for the next step, whether that is new paving, a slab pour or landscaping. If you plan to pour new concrete right after, coordinate the schedule so the base is graded and ready, which saves a second mobilization and keeps the site from sitting open.

Deck Construction, Repair & Refinishing

A new deck built, a tired one repaired, or its framing, boards, railing and finish renewed — foo…

Fence Installation, Repair & Replacement

A new fence built where none exists, an old one replaced, or leaning sections, broken boards and…

Stucco Repair & Replacement

Hairline cracks to full sections patched and color-matched to blend right in.

Siding Repair

Wood, Hardie, and vinyl siding repaired or replaced, board or section.

Concrete Installation, Replacement & Repair

A new patio, walkway, or driveway poured in broom, smooth, exposed-aggregate, stamped, colored,…

Caulking & Weatherproofing

A full exterior caulk and seal — best done in fall, before the Bay Area rains.

Gutter Installation, Replacement & Repair

New seamless gutters installed where none exist, an old, leaking, or sagging system fully replac…

Roof Repair & Maintenance

Non-structural shingle, flashing, and minor leak repair, sealed up and weather-tight. Storm or f…

Gutter Guard Installation

Micro-mesh and reverse-curve guards that end seasonal gutter cleaning for good.